Personalised Settings - Delta Q MILKQOOL Manuel D'utilisation

EN INSTRUCTIONS AND MODE OF USE
64
A. B. C.
A. C.
B.
Fig. 16: Programming the coffee
extraction button.

PERSONALISED SETTINGS

The control panel buttons can also be used to personalise the dosages of
the different drinks.
Programming the espresso extraction button.
Note: The pre-defined factory volume for the espresso extraction button
is around 30cc.
• T o alter the volume of your beverage, ensure the machine is ON (see Fig.5),
check whether there is any water in the water tank and wait until the
control panel buttons indicate "Ready to use" (see Fig. 7).
• Then press the espresso extraction button until the indicator lights of
the long and the tea extraction buttons start blinking.
D.
Press the espresso extraction button (see Fig. 16).
The indicator lights of the long and the tea extraction buttons go out.
Note: If the user does not press again the espresso extraction button after 1
D.
minute, the equipment will revert automatically to the "Ready to use" mode.
• As soon as extraction has reached the desired dosage, press the
espresso extraction button again and the operation is complete.
The equipment memorises this volume and will start extracting it until
new programming has been defined.
• After completing extraction, the equipment returns to "Ready to use"
mode (see Fig. 7).
Note: If the user fails to press the extraction button to complete the
operation, the equipment will automatically assume the volume around
of 75cc.