Troubleshooting - EINHELL GC-EM 1743 HW Instructions D'origine

11. Troubleshooting

Fault
The motor fails to
start
The motor perfor-
mance drops
Cutting is irregular
Important! For protection, the motor is equipped with a thermal switch which cuts out when
the motor is overloaded and switches on again automatically after a short cooling period.
Anl_GC_EM_1743_HW_SPK7.indb 26 Anl_GC_EM_1743_HW_SPK7.indb 26
GB
Possible causes
a) The capacitor is defective
b) There is no electricity at the plug
c) The cable is defective
d) The combined switch/plug is de-
fective
e) The connectors have become
separated from the motor or the
capacitor
f) The mower is standing in high
grass
g) The mower housing is clogged
a) The grass is too high or too damp
b) The mower housing is clogged
c) The blade is severely worn
a) The blade is worn
b) Wrong cutting height
- 26 -
Remedies
a) The mower housing is clogged.
Have repaired by the Customer
Service Center
b) Check the cable and the fuse
c) Check the cable
d) Have repaired by the Customer
Service Center
e) Have repaired by the Customer
Service Center
f) Start in low grass or on an area that
has already been mowed; change
the cutting height if necessary
g) Clean the housing so that the blade
moves freely
a) Correct the cutting height
b) Clean the housing
c) Replace the blade
a) Replace or resharpen the blade
b) Correct the cutting height
26.09.2016 09:27:21 26.09.2016 09:27:21