11. Troubleshooting
Fault
The motor fails to
a) The capacitor is defective
start
b) There is no electricity at the plug
c) The cable is defective
d) The combined switch/plug is de-
fective
e) The connectors have become
separated from the motor or the
capacitor
f) The mower is standing in high
grass
g) The mower housing is clogged
The motor perfor-
a) The grass is too high or too damp
mance drops
b) The mower housing is clogged
c) The blade is severely worn
Cutting is irregular
a) The blade is worn
b) Wrong cutting height
Important! For protection, the motor is equipped with a thermal switch which cuts out when
the motor is overloaded and switches on again automatically after a short cooling period.
Anl_BG_EM_1030_SPK1.indb 26
Anl_BG_EM_1030_SPK1.indb 26
GB
Possible causes
a) The mower housing is clogged.
b) Check the cable and the fuse
c) Check the cable
d) Have repaired by the Customer
e) Have repaired by the Customer
f) Start in low grass or on an area that
g) Clean the housing so that the blade
a) Correct the cutting height
b) Clean the housing
c) Replace the blade
a) Replace or resharpen the blade
b) Correct the cutting height
- 26 -
Remedies
Have repaired by the Customer
Service Center
Service Center
Service Center
has already been mowed; change
the cutting height if necessary
moves freely
12.04.12 17:08
12.04.12 17:08