DeWalt D55146 Guide D'utilisation page 12

A
A
B
2. Pull handle (A) until fully extended (lock position).
WARNING: Risk of unsafe operation. Ensure proper footing and
use caution when rolling compressor so that unit does not tip or
cause loss of balance.
3. To move, roll compressor on tires using handle (A) as shown
above.
Store compressor in a vertical or horzitional position.
PrEPArATION FOr uSE
WARNING: Do not operate this unit until you read and understand
this instruction manual for safety, operation and maintenance
instructions.
Pre-Start Checklist (Fig. 1)
1. Ensure the Auto/Off switch (L) is in the OFF position.
2. Plug the power cord into the correct branch circuit receptacle. See
Voltage and Circuit Protection under Installation.
3. Ensure air tank is drained, see Draining Air tank under
Maintenance.
4. Ensure the drain valve (M) is closed.
5. Ensure safety valve (G) is functioning properly, see Checking
safety Valve under Maintenance.
6. Pull the regulator knob (F) out and turn counterclockwise until fully
closed. Ensure regulated pressure gauge reads 0 psi. Push knob
in to lock in place.
B
. Attach hose and accessories.
7
3/8" (9.5 mm) or greater air hose rated at 300 psi.
WARNING: Risk of unsafe operation. Firmly grasp air hose in hand
when installing or disconnecting to prevent hose whip.
WARNING: Risk of unsafe operation. Do not use damaged or worn
accessories.
WARNING: Risk of Bursting. Too much air pressure causes a
hazardous risk of bursting. Check the manufacturer's maximum
pressure rating for air tools and accessories. The regulator outlet
pressure must never exceed the maximum pressure rating.
OPErATING PrOCEDurES
Start-up (Fig. 1)
1. Follow Pre-start Checklist under Preparation for Use.
NOTICE: Risk of property damage. Do not operate in vertical
position. Vertical position is for storage only.
2. Move the Auto/Off switch to the AUTO position and allow tank
pressure to build. Motor will stop when tank pressure reaches
cut-out pressure.
CAUTION: Risk of unsafe operation. Compressed air from the unit
may contain wa ter condensation and oil mist. Do not spray un fil tered
air at an item that could be damaged by moisture. Some air op er­
ated tools or de vic es may require filtered air. Read the in struc tions
for the air tool or device.
3. Adjust regulator (F) to desired setting. See regulator under
Features.
Shut-down (Fig. 1)
1. Move Auto/Off switch (L) to the OFF position. nOte: If finished
using compressor, follow Steps 2 - 6.
nOte: When the unit has been turned off, it is normal to hear a short
hiss of air being released.
12
nOte: Always use a minimum