Emptying The Dust Container; Cleaning The Hepa Filter; Cleaning The Brush Nozzle - Cleanmaxx T-110-80 Mode D'emploi

Emptying the Dust Container

Cleaning the HEPA Filter

4. Take the HEPA fi lter out of the dust fi lter insert
5. Tap out the HEPA fi lter.
6. If necessary, thoroughly rinse the HEPA fi lter and the dust fi lter insert with clear,
lukewarm water. CAUTION: Do not under any circumstances clean the fi lter in a wa-
shing machine or dishwasher! Then shake off any excess water and let the fi lter and
the fi lter protective frame dry completely in the air before you insert them both again.
7. Place the HEPA fi lter back onto the dust fi lter insert.
8. Insert the dust fi lter insert together with the HEPA fi lter back into the dust container
and turn it tight.
9. Then place the dust container back into the device. Make sure that the dust contai-
ner locks in place correctly.

Cleaning the Brush nozzle

1. Hold the device over an open dustbin.
2. Press the release button to open the dust container. The
bottom of the dust container will open and the dirt will fall out.
3. Then fl ip the dust container fl ap closed again. The fastener
must be heard to engage in place.
4. If necessary, you can rinse the dust container with clear,
lukewarm water. To do this, remove the dust container
from the device (see the „Cleaning the HEPA Filter"
chapter).
1. To make it easy to clean the brush nozzle, you can open
the nozzle: Open the dust compartment on the bottom of
the nozzle by pushing both hooks in.
20
1. Remove the fl oor or tile nozzle as de-
scribed in the chapter "Connecting
the Crevice Nozzle / Brush Vacuum
Floor Nozzle".
2. Turn the dust bin slightly to the left to
remove it from the main unit.
3. Pull out the dust fi lter insert together
with the HEPA fi lter.