Dometic Waeco PerfectView CAM44 Instructions De Montage Et De Service page 37

PerfectView CAM44
8.2 Fitting the camera
!
CAUTION!
Select a location for the camera and attach it firmly enough so that
it cannot under any circumstances fall off and injure bystanders
(e.g. by being knocked off by branches brushing over the roof of
the vehicle).
I
NOTE
If installing the camera alters the vehicle height or the length spec-
ified in the vehicle documents, your vehicle must be inspected by
the appropriate authorities.
Make sure that you are in possession of vehicle documents veri-
fying that your vehicle has passed this inspection.
Observe the following installation instructions:
 Fix the camera at a height of at least two metres for an adequate view.
Make sure that you have a firm place from which to work when installing
the camera.
 Make sure that the installation location of the camera is sufficiently firm
(e. g. to prevent the camera from being knocked down by branches that
may brush the roof of the vehicle).
 Mount the camera horizontally and in the middle of the rear of the vehicle
(fig. d, page 7).
 Always use the supplied insulation pad (fig. 8 5, page 5). This prevents
residual current caused by a poor earth connections in the vehicle. Resid-
ual current can cause lines of interference in the picture or buzzing in the
loudspeakers or even damage components.
 The most secure type of attachment is with screws fitted through the
body. Please observe the following instructions:
– There must be sufficient space behind the chosen installation location
to be able to carry out the mounting procedure.
– Suitable measures must be taken to prevent water penetrating through
any holes made (e.g. by using screws and sealant and/or spraying the
outer attachment parts with a sealant).
– The location on the body where you wish to attach the camera must
be rigid enough to allow the camera to be tightly fastened.
 Check beforehand that there is sufficient space on the other side for the
drill head to come out (fig. 2, page 4).
EN
Fitting the camera
37