Assembly; Operation - Ryobi HP74L Manuel D'utilisation

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Driving screws with screwdriver bits
 Light-duty drilling
TO CHARGE
See Figure 1, page 9.
 Insert the micro-USB cable into the product as shown.
 Connect the micro-USB cable to any powered USB port,
or connect it to a USB power adapter (not included) and
plug the adapter into a power supply.
NOTE: Make sure the power supply is normal household
voltage, 120 volts, AC only, 60 Hz.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to pos-
sible serious personal injury.

OPERATION

 The LED charge indicator will turn on while charging and
turn off once the screwdriver is fully charged or when the
USB cable is disconnected.
 Upon full battery depletion, an estimate of 5 hours of
charging time is required to fully recharge the screwdriver.
 Do not place charger in an area of extreme heat or cold.
It will work best at normal room temperature.
 Remove the product from the USB power adapter (not
included) or powered USB port once it is fully charged
and ready for use.
 Disconnect the micro-USB cable from the screwdriver.
SWITCH TRIGGER
See Figure 2, page 9.
To turn the tool ON, depress the switch trigger. To turn it
OFF, release the switch trigger and allow the collet to come
to a complete stop.
NOTE: A whistling or ringing noise coming from the switch
during use is a normal part of the switch function.
LED LIGHT
See Figure 2, page 9.
The LED light, located beneath the collet, illuminates when
the switch trigger is depressed.
6 – English