Features; Assembly; Operation - Ryobi HP53L Manuel D'utilisation

PRODUCT SPECIFICATIONS
No Load Speed .................................200/600 r/min. (RPM)
Clutch .............................................................. 24 Positions
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance. In Mexico, please call 01-800-843-1111.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.

FEATURES

Torque ....................................................................
Collet ..............................................SpeedLoad+™ System

ASSEMBLY

WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.

OPERATION

APPLICATIONS
You may use this product for the purposes listed below:
 Driving screws with screwdriver bits
 Light-duty drilling
For complete charging instructions, refer to the Operator's
Manual for the battery packs and chargers for your models.
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 8.
To install the battery pack:
 Unscrew the battery cap.
 Insert the battery pack in the direction shown. Make sure
the raised rib on the battery pack aligns with the groove
in the compartment.
 Place the cap over the battery pack and push down
until the cap meets the threads at the end of the battery
compartment.
 Screw the cap on securely.
To remove the battery pack:
 Unscrew the cap. The battery pack will disconnect and
be easy to remove.
 Do not attempt to use this product if the battery cap is
not securely closed.
5 — English
40 in. lb.