Hitachi DS 14DSAL Instructions De Sécurité Et Mode D'emploi page 16

English
13. How to select tightening torque and rotational speed
CAUTION
The selection examples shown in Table 6 should be considered as general standard. As different types of
tightening screws and different materials to be tightened are used in actual works proper adjustments are
naturally necessary.
Use
Machine screw
Driving
Wood screw
Wood
Drilling
Metal
NOTE
The use of the battery BSL1415X and BSL1815X in
a cold condition (below 0 degree Centigrade) can
sometimes result in the weakened tightening
torque and reduced amount of work. This,
however, is a temporary phenomenon, and returns
to normal when the battery warms up.
16
Table 6
Rotating speed selection (Position of the shift knob)
Clutch dial position
For 4 mm or smaller
1 – 22
diameter screws.
For 8 mm or smaller
1 –
nominal diameter screws.
For 45 mm or smaller
diameters. (DS18DSAL)
For 24 mm or smaller
diameters. (DS14DSAL)
LOW (Low speed)
CAUTION
While operating the cordless driver drill, take care
not to lock the motor.
If the motor is locked, immediately turn the power
off.
If the motor is locked for a while, the motor or
battery will be burnt.
Do not tighten too strongly as the screw heads
will be damaged.
HIGH (High speed)
For 6 mm or smaller
diameter screws.
For 4.8 mm or smaller
nominal diameter screws.
For 38 mm or smaller
diameters. (DS18DSAL)
For 18 mm or smaller
diameters. (DS14DSAL)
For drilling with a metal
working drill bit.