Blower Assembly; Electrical Box - Dometic CLIMATE MCS T6 Instructions De Montage

Installation
8.3

Blower Assembly

Rotate the blower to allow the most direct flow of air to the supply-air grille
(fig. 5, page 4).
➤ Loosen the adjustment screw (1).
➤ Rotate the blower (2).
➤ Tighten the adjustment screw (1).
8.4

Electrical Box

Mind the following notes on the installation of the electrical box (fig. 8 3,
page 6):
•
Mount the electrical box in a dry location.
•
Mount the electrical box to a flat, solid surface within 1 m of the unit.
•
Mount the electrical box within 4.5 m of the location where the digital con-
trol will be installed.
➤ Use the 4 mounting slots in the back of the electric box to attach it to a suita-
ble mounting surface.
➤ Use screws appropriate for mounting surface (not included).
8.5 Supply-Air Grille
Mind the following notes on the installation of the supply-air grille to ensure
direct uninterrupted airflow from the blower:
A
NOTICE!
In no instance should the supply-air grille discharge be directed towards the
return-air grille, as this will cause the system to short cycle.
•
Install the supply-air grille as high as possible.
•
A minimum clearance of 76 mm plus the duct diameter size is required
behind the supply-air grille for attaching the ducting.
➤ Create the cut outs for the supply-air grille according to the following table:
MCS T6
4.9" x 4.9"
125 x 125 mm
➤ Mount the supply-air grille.
20
MCS T6, MCS T12, MCS T16
MCS T12
9.9" x 5.9"
252 x 150 mm
MCS T16
9.9" x 7.9"
252 x 201 mm
EN