Dometic CLIMATE MCS T6 Instructions De Montage page 24

Installation
8.10 Unit and Seawater System Installation
8.10.1 Notes on Seawater System Installation
A
NOTICE!
If the sea water screen filter is not installed, the pump can be damaged.
I
NOTE
If the sea water screen filter is not installed, the warranty for the pump will be
void.
Key to fig. 6, page 5
Item
1
2
3
4
5
6
7
8
9
10
– A: Correct
Steady upward flow from inlet to unit (8), then downward to outlet (9),
hoses double clamped (10).
– B: Incorrect
Hoses must not have kinks, loops or high spots where air can be trapped.
– C: Incorrect
Pump (4) and strainer (3) must be below water line (7).
– D: Incorrect
Strainer (3) must be below pump (4) and below waterline (7).
Mind the following notes on the installation of the seawater system:
•
The seawater pump must be mounted so that it is always at least 300 mm
below the water line.
•
The seawater pump may be mounted horizontally or vertically, however the
discharge must always be above the inlet (fig. 7, page 6).
•
Ensure the water is flowing freely from overboard discharge while the pump
is running.
24
Description
Scoop type thru-hull inlet
Ball valve
Strainer
Seawater pump
DTU unit
Overboard discharge
Water line
Inlet flow
Outlet flow
Hose clamps, installed in pairs with adjustment ends on opposite
sides
MCS T6, MCS T12, MCS T16
EN