Carel ultimateSAM Mode D'emploi page 29

8
9
10
11
12
Installation of the condensate drain kit for SA0 (single-pipe)
(optional, sold separately) SACK*S10*0
Place the upright in the 100 mm (3.9") opening made in the duct
Tighten the support flange bolts to 7-8Nm (5-6ft), using the fastening elements supplied. If
necessary, cut the bolts
View of the installation, part inside the duct: upright
View of the installation, part outside of the duct: manifold
Apply the AHU wall cover kit for SA0 (not supplied, available separately): SAKIL00000
Installation of the thermostatic drain kit for SA0 (single-pipe)
29
(optional, sold separately) SAKT*H00*0
Note: Not available in North America.
"ultimateSAM - user" +03U0070EF - rel. 2.0 - 20150301
ENG