Starting Operation - Bosch GDB 1600 WE Professional Notice Originale

OBJ_BUCH-116-003.book Page 22 Thursday, November 18, 2010 11:49 AM
22 | English
Dust Extraction via Suction Head
Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
– As far as possible, use a dust extraction
system suitable for the material.
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
Insert the vacuum hose 18 of an all-purpose vac-
uum cleaner (accessory) into the vacuum con-
nection 17 on the suction head.
Operation

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Before beginning work, consult the struc-
tural engineer, architect or construction su-
pervisor in charge. Only cut through rein-
forcements with the permission of a
structural engineer.
When core drilling through walls or floors,
ensure to check the respective rooms/en-
closures for obstructions. Barrier off the
construction site and secure the drilled out
core against falling down with the use of
casing or similar.
1 609 929 V13 | (18.11.10)
Operational Check of the Residual Current
Device (GDB 1600 WE)
Check the proper function of the residual cur-
rent device 4 each time before working:
– Push the "RESET" button on the residual cur-
rent device. The service readiness of the re-
sidual current device is signalled through a
red control indicator.
– Push the "TEST" button. The indicator above
the "RESET" button becomes black.
Switching On
GDB 1600 WE: Push the "RESET" button on the
residual current device 4.
GDB 1600 WE with flusing head 6: Open the
water cock 10. Check the flow of water at the
water-flow indicator 8.
To start the power tool, press the On/Off
switch 3.
To lock the On/Off switch, keep it pressed and
additionally push the lock-on button 2.
Switching Off
Release the On/Off switch 3. When the On/Off
switch 3 is locked, press the On/Off switch first
and then release.
GDB 1600 WE with flusing head 6: Shut the wa-
ter cock 10. After finishing work, disconnect the
water outlet connector 5 from the water supply.
Open the water cock 10 and drain the remaining
water.
Adjusting the Speed
The speed of the switched on power tool can be
variably adjusted, depending on how far the
On/Off switch 3 is pressed.
Two speed ranges can be preselected with the
gear selector 22.
The two gears are recommended for the follow-
ing bore diameters:
1st gear
Wet drilling 33–102 mm
Dry drilling 69–152 mm
2nd gear
10–32 mm
32–68 mm
Bosch Power Tools