Power Supply; Set-Up Recommendations; Inserting Batteries In The Remote Control - Philips CDR 560 Mode D'emploi

INSTALLATION

Power supply

1 Plug the power cord supplied into the MAINS connector on
the CD recorder, then into a wall socket.
2 Press ON/OFF to turn the CD recorder on.
Note:
- The CD recorder will automatically adjust to the local mains
voltage.
- When the CD recorder is in the "OFF" position, it is still
consuming some power. If you wish to disconnect your CD
recorder completely from the mains, withdraw the plug from
the AC Outlet.

Set-up recommendations

- Place the CD recorder on a solid, vibration free surface.
- Do not place the CD recorder near a source of heat or in
direct sunlight.
- Do not use the CD recorder under extremely damp
conditions.
- If the CD recorder is placed in a cabinet, make sure that a
one-inch space remains free on all sides of the recorder for
proper ventilation.
10

Inserting batteries in the remote control

CDR 560
Note: For CDR538 see Remote Control FW538.
1 Open the battery compartment cover.
2 Insert 2 batteries (AAA, R03 or UM-4; as supplied) as
shown.
3 Replace the cover.
Note: We recommend using 2 batteries of the same type and
condition.
Batteries contain chemical substances; dispose of
them properly.