Synchronized Digital Recording - Cd-Sync - Philips CDR 560 Mode D'emploi

Start digital recording
1 With the recorder stopped, press RECORD to enter the
Record standby mode.
➜
will flash.
RECORD
DIG AUTO TRACK REPEAT 1 TOTAL
ANALOG
PROG
RECORDABLE L
• If also flashes, the digital connection is incorrect.
DIG
2 To start recording, press PLAY and immediately start the
source (from stop mode).
➜
lights continuously. The track number and
RECORD
recording time used will be indicated on the display.
• To record a 3-second silence at the start of a track, press
PAUSE.
• To check the (remaining) recording time, press DISPLAY.
(This can also be done during the recording.)
3 To stop recording, press STOP on the CD recorder.
➜
will go out.
RECORD
• To interrupt recording, press PAUSE.
➜
starts to flash. Resume at step 2.
RECORD
After recording the display will show UPDATE for several
seconds.
Note: With on, the recorder will stop
AUTO TRACK
automatically. Recordings from DAT or DCC will stop
after 20 seconds silence. With
mode is disabled.
STOP
REM TRACK TIME CD SYNC
RECORD
FINALIZE
ERASE
COPY
off, the
AUTO TRACK AUTO

Synchronized digital recording - CD-SYNC

Preparing for synchronized digital recording
The CD-SYNC feature enables you to make a fast and easy
digital recording of a CD. Track increments are automatically
detected from the digital source material. Track increments
cannot be added manually.
1 Make sure the disc is absolutely free of scratches and dust
particles.
2 Press Source repeatedly until (depending on the connection
used):
➜
COAXIAL or OPTICAL will appear on the
DIG DIG
display.
Start synchronized digital recording
1 With the CD recorder stopped, press CD-SYNC.
➜ On the display,
- & SYNC appears. After a
CD SYNC
time, starts to flash.
RECORD
REPEAT 1
DIG AUTO TRACK TOTAL
ALOG
PROG
• If also flashes, the digital connection is incorrect.
DIG
2 To start recording, press Play on the digital source.
➜ The CD recorder automatically starts to record and
lights continuously. The track number and
RECORD
recording time used will be indicated on the display
• If you start the source during a track, CD-SYNC will not
start recording until the beginning of the next track.
• To check the (remaining) recording time, press Display.
(This can also be done during recording)
3 To stop recording, press STOP on the CD recorder.
➜
- and will go out.
CD SYNC RECORD
• To interrupt recording, press PAUSE.
➜
will start to flash. To resume, press PLAY on the
RECORD
CD recorder.
RECORDING
REM TRACK TIME CD SYNC
RECORD
FINALIZE
ERASE
COPY
13