Erasing & Playing; Erasing Cd-Rw Discs; Playing A Cd; Selecting A Track Or Searching - Philips CDR 560 Mode D'emploi

ERASING & PLAYING

Erasing CD-RW discs

For CD-RW discs only.
You can erase:
- track by track from the end.
- the entire disc.
To erase the last track :
1 Make sure the disc is not finalized (Showing OPC on
display during start up). Otherwise unfinalize first (p. 15)
2 Press ERASE.
➜ On the display, TRACK and
DIG AUTO TRACK REPEAT 1 TOTAL
LOG
PROG
C
3 Press RECORD within 3 seconds.
➜ TRACK and
light continuously during erasure.
ERASE
To erase the entire disc:
1 Press ERASE once (for finalized CD-RW) and twice (for
unfinalized CD-RW).
➜ On the display, DISC and
AUTO TRACK REPEAT 1 TOTAL
DIG
ALOG
PROG
C
2 Press RECORD within 3 seconds.
➜ DISC and
light continuously during erasure.
ERASE
Erasure of a complete disc may take up to 1.5 minutes.
16
will flash.
ERASE
REM TRACK TIME CD SYNC
RECORD
FINALIZE
ERASE
COPY
will flash.
ERASE
REM TRACK TIME
CD SYNC
RECORD
FINALIZE
ERASE
COPY

Playing a CD

1 Press PLAY to start CD play.
➜ The track number and track time appear on the display,
together with the record/play level indicator.
2 Press Display once, twice, or three times to see:
➜ remaining track time; Total remaining time; Track time
with the record/play level bar off.
3 To interrupt play temporarily, press PAUSE.
➜
will light up on the display
PAUSE
4 To continue play, press PAUSE again or press PLAY.
5 To stop play, press STOP.
➜ The number of tracks and the total playing time will
appear on the display

Selecting a track or searching

Selecting a track during play
1 Briefly press ∞ or § one or more times.
➜ Play skips to the beginning of the present, previous or
following track.
or
• Press the required track number using the numerical keys
on the remote control. For 2-digit track numbers, press the
keys in rapid succession.
➜ Play skips to the beginning of the selected track.