Power Supply - Philips MAGNAVOX AZ 2725 Mode D'emploi

POWER SUPPLY

BATTERIES
Whenever convenient, use the power supply if you want to conserve
battery life. Make sure you remove the power plug from the set and the
wall outlet before inserting batteries.
Batteries (optional)
1. Open the battery compartment and insert as shown six batteries,
type R20, UM1 or D-cells.
Remote control batteries (included)
1. Open the battery compartment and insert as shown two batteries, type
AAA, R03 or UM4.
2. Replace the compartment door, making sure the batteries are firmly
and correctly in place.
3. Remove dead batteries or batteries that will not be used for a long
time.
– The incorrect use of batteries can cause electrolyte leakage, corrode
the compartment or cause the batteries to burst. Therefore:
– Do not mix battery types, e.g. alkaline with zinc carbonate.
– When inserting new batteries, replace all batteries at the same time.
Note: The battery supply is switched off when the set is connected to
an AC power supply.
AC POWER
1. Check if the power voltage shown on the type plate (on the base of the
set) corresponds to your local power voltage. If it does not, consult
your dealer or service organization.
2. If your set is equipped with a voltage selector, set it to the local power
voltage.
3. Connect the power cord to the MAINS ~ outlet and the wall outlet.
– The set is now ready to use.
4. To switch off the AC power supply completely, pull the power plug out
of the wall outlet.
– Disconnect the power cord when you change over to battery supply, or
to protect the set during heavy thunderstorms.
The type plate is located on the base of the set.
Environmental information
All redundant packaging material has been omitted. We have done our utmost to make the packaging easy to
separate into three mono materials: cardboard (box), expandable polystyrene (buffer) and polyethylene (bags,
protective foam sheet).
Your set consists of materials which can be recycled if disassembled by a specialized compa-
ny. Please observe the local regulations regarding the disposal of packaging materials, dead
batteries and old equipment.
8
6 x D-cells - R20 - UM1
MAINS