Philips MAGNAVOX AZ 2725 Mode D'emploi page 16

TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to solve a problem by following these hints, consult your dealer or service center.
WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the
warranty.
PROBLEM
Set does not react to operation
of any button.
Display does not function
properly.
No sound.
Bad sound.
No sound on left or right side.
Reversed left and right sound.
Severe radio hum or noise.
Poor radio reception.
Poor cassette sound quality.
Recording does not work.
CD playback does not work.
The CD skips tracks.
16
POSSIBLE CAUSE
– Electrostatic discharge.
– Electrostatic discharge.
– Set runs on batteries.
– VOLUME is not adjusted.
– Headphones are connected.
– Batteries are dead.
– Batteries are incorrectly
inserted.
– Power cord is not securely
connected.
– Unsuitable speakers are used.
– Batteries are dead.
– Speaker wrongly connected.
– Speakers are wrongly
connected.
– Set too close to TV, VCR or
computer.
– Weak radio signal.
– Dust and dirt on the heads,
capstan or pressure roller.
– Cassette tab(s) may be broken
out.
– CD is badly scratched or dirty.
– No CD inserted.
– CD inserted upside down.
– CD player lens is steamed up.
– CD is damaged or dirty.
– PROGRAM/SHUFFLE is active.
REMEDY
• Switch off the set, disconnect
the power plug, then reconnect
after a few seconds.
• Switch off the set, disconnect
the power plug, then reconnect
after a few seconds.
• Switch to AC power.
• Adjust the VOLUME.
• Disconnect headphones.
• Insert fresh batteries.
• Insert the batteries correctly.
• Connect the power cord
properly.
• Use supplied speakers.
• Replace batteries.
• Connect speaker properly.
• Connect speakers properly, L to
left, R to right.
• Increase the distance.
• FM: aim and extend the
external antenna for best
reception;
• AM: rotate the entire set.
• Clean the heads, etc. See
Maintenance.
• Put a piece of cellophane tape
over the missing tab space.
• Replace or clean the CD. See
Maintenance.
• Insert CD.
• Insert CD with printed side
facing up.
• Wait until lens is clear.
• Replace or clean the CD.
• Switch off the
PROGRAM/SHUFFLE function.