Loading
1.
Squeeze the height adjust lever, and raise the auger to the HIGH
position (P.
22
2.
Lower the discharge chute all the way down by operating the
discharge chute adjust switch.
3.
Use reverse gear to back the snowblower up the ramp.
4.
Use extreme care not to hit the discharge chute against the hood or
any other parts of the truck.
Avoid stopping the snowblower on the ramp. Should the engine
stop, be sure to move the shift lever back to the NEUTRAL before
attempting to restart the engine.
Never leave the transmission release lever in the RELEASED
position while loading; the snowblower may start suddenly,
resulting in serious injury or accident.
DOWN
UP
).
REVERSE
1.5 m (5 ft)
minimum headroom
67