Maintenance - Honda Power Products HSS970 Manuel De L'utilisateur

Periodic inspection and maintenance will help extend the service life
of your snowblower while keeping it in the best operating condition.
Inspect or service as described in the table below.
Shut off the engine before performing inspection and maintenance,
and disconnect the spark plug wire from the plug so the engine
cannot be started.
If the engine must be run, make sure the area is well-ventilated.
Exhaust gas contains poisonous carbon monoxide; exposure can
cause loss of consciousness and may lead to death.
To avoid overturning, place the snowblower on a level surface
before performing inspection and maintenance.
Use only genuine Honda parts or their equivalent.
Replacement parts which are not of equivalent quality may damage
the snowblower.
Tools
A spark plug wrench and handle are supplied with the snowblower.
Some of the maintenance procedures described in this manual will
require a set of metric wrenches (not supplied).
SPARK PLUG
WRENCH
WRENCH
HANDLE
×
10 12 mm
BOX END
WRENCH
14 × 17 mm
WRENCH
TOOL BAG

MAINTENANCE

9.
6 mm SELF LOCK NUTS (3)
LOCK BOLTS (3)
FUSE 5 A
(ETS, EWS)
FUSE 30 A
(ETS, EWS)
FUSE RUBBER
(ETS, EWS)
53