Honda Power Products HSS970 Manuel De L'utilisateur page 28

Hydrostatic transmission fluid
Check the hydrostatic fluid level in the reservoir.
Hydrostatic fluid expands and contracts with changes in temperature.
The UPPER and LOWER level marks on the reservoir are calibrated for
room temperature fluid.
It is normal for the fluid level to rise above the UPPER level mark when
snowblower operation warms the transmission.
When checking the level of cold fluid, below room temperature, refer
to the temperature chart for appropriate fluid levels.
At temperatures below
reservoir before operation, but should rise into the reservoir when the
transmission warms up.
TRANSMISSION
FLUID RESERVOIR
If the fluid level is low, add Honda Hydrostatic Fluid.
The use of other hydrostatic fluids will reduce transmission
performance and may damage the transmission. Use only Honda
Hydrostatic Fluid.
1.
Unscrew the reservoir cap and remove the seal. Be careful to
prevent dirt, water, or snow from entering the reservoir.
2. Add Honda Hydrostatic Fluid to bring the fluid level to the UPPER
level mark at room temperature, or to the appropriate level shown in
the temperature chart. Do not overfill.
3. Reinstall the seal, and tighten the cap securely.
Temp.
20°C Between upper and lower levels
(68°F) (approx. 5 mm (0.20 in) above lower level)
10°C Slightly above lower level
(50°F) (approx. 2 mm (0.08 in) above lower level)
0°C Slightly below lower level
(32°F) (approx. 1 mm (0.04 in) below lower level)
− 10°C Between lower level and bottom of oil tank
(14°F) (approx. 4 mm (0.16 in) below lower level)
− −
20 °C ( 4 °F), fluid may not be visible in the
Oil level
UPPER LEVEL
LOWER LEVEL
20°C
10°C
0°C
−
10°C
UPPER
LEVEL
LOWER
LEVEL
25