Honda Power Products HSS970 Manuel De L'utilisateur page 68

Discharge distance adjustment Manual adjustment
(ETS, EWS)
1. Remove the motor cover (see page
2. Remove the lock pin.
Loosen the lock nut and remove the guide cable from the holder.
Remove the gear by removing the center bolt.
GUIDE CABLE
LOCK NUT
3. Hold the discharge chute guide so that it is positioned lowest, install
the gear as shown.
4. Install the guide cable and lock pin in the reverse order of removal.
Tighten the lock nut securely.
5. Reinstall the motor cover (see page
GUIDE CABLE
LOCK NUT HOLDER
Have your snowblower inspected and repaired by your authorized
Honda dealer as soon as you complete the snow removal operation.
−
LOCK PIN
HOLDER
LOCK PIN
DISCHARGE
CHUTE GUIDE
64 ).
64 ).
GEAR
GEAR
CENTER BOLT
CENTER BOLT
65