Items Supplied; Proper Use - EINHELL BS 315 UG Mode D'emploi

Anleitung BS 315 UG SPK1
1. Layout (Fig. 1 / 2)
1. On/Off switch
2. Chain bar
3. Rubber tires
4. Hand wheel
5. Base plate
6. Dust extraction connector
7. Lower blade pulley
8. Upper blade pulley
9. Tightening screw
10. Wheels
11. Upper blade guide
12. Side cover
13. Cover fastener
14. Retaining screw for upper blade pulley
15. Machine table
16. Dial scale for tilt angle
17. Table insert
18. Fixing handles for table
19. Adjustable handle for blade guide
20. Fixing handle for blade guide
21. Legs
22. Setting screw for upper blade pulley
23. Parallel stop
24. Machine frame
25. Blade

2. Items supplied

Bandsaw
Machine table
Push stick
Parallel stop
Base frame
Blade
Wheels

3. Proper use

The bandsaw is intended for the slitting and cross-
cutting of timber or wood-like workpieces.
Round materials may only be cut with suitable
holding devices.
The machine is to be used only for its prescribed
purpose.
Any other use is deemed to be a case of misuse.
The user/operator and not the manufacturer will be
held liable for damage and/or injuries of any kind that
result from such misuse.
The machine is to be operated only with suitable saw
blades. To use the machine properly you must also
02.11.2005 8:49 Uhr Seite 17
observe the safety regulations, the assembly
instructions and the operating instructions to be
found in this manual.
All persons who use and service the machine have
to be acquainted with this manual and must be
informed about the machine's potential hazards.
It is also imperative to observe the accident
prevention regulations in force in your area.
The same applies for the general rules of health and
safety at work.
The manufacturer will not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machine's construction and
design:
Damage to hearing if ear-muffs are not used as
necessary.
Harmful emissions of wood dust when used in
closed rooms.
Contact with the blade in the uncovered cutting
zone.
Injuries (cuts) when changing the blade.
Injury from catapulted workpieces or parts of
workpieces.
Crushed fingers.
Kickback.
Tilting of the workpiece due to inadequate
support.
Touching the blade.
Catapulting of pieces of timber and workpieces.
4. Important information
Safety information
CAUTION! Whenever you use electric tools it is
imperative to take basic safety precautions in order
to reduce the risk of fire, electric shock and personal
injury. Essential safety precautions include:
1. Keep your work area tidy!
- An untidy work area invites accidents.
2. Check the working conditions
- Do not expose electric tools to rain.
- Never use electric tools in damp or wet
locations.
- Make sure there is good lighting.
- Do not use electric tools near flammable liquids
or gases.
3. Guard against electric shock!
- Avoid body contact with earthed components.
4. Keep other persons away
- Do not allow other persons, particularly children,
to touch the tool or cable. Keep them away from
GB
17