Technical Data; Noise Emission Values; Before Starting The Machine - EINHELL BS 315 UG Mode D'emploi

Anleitung BS 315 UG SPK1
prevent it being switched on again accidentally
after a power failure.
31. Before you use the machine for the first time,
check that the voltage marked on the rating plate
is the same as your mains voltage.
32. If you use a cable reel, the complete cable must
be pulled off the reel.
33. Persons working on the machine should not be
distracted.
34. Note the direction of rotation of the motor and
blade.
35. Never dismantle the machine's safety devices or
render them inoperative.
36. Never cut workpieces which are too small to hold
securely in your hand.
37. Never remove loose splinters, chips or jammed
pieces of wood when the saw blade is running.
38. It is imperative to observe the accident
prevention regulations in force in your area as
well as all other generally recognized rules of
safety.
39. Note the information published by your
professional associations.
40. Position the blade guard so it is approx. 3 mm
above the material you want to saw.
41. Important! Secure long workpieces against
falling off at the end of the cut (e.g. with a roller
stand etc.) (e.g. roller table etc.)
42. Make sure the blade guard (10) is in its lower
position when the saw is being transported.
43. Safety guards are not to be used to move or mis-
use the machine.
44. Blades that are deformed or damaged must not
be used.
45. If the table insert is worn, replace it.
46. Never start the machine up if the door protecting
the blade or the separating protective device is
open.
47. Make sure that the chosen blade and speed are
suitable for the material that is to be cut.
48. Do not start to clean the blade until it has come
to a complete stop.
49. In the case of straight sawing against the parallel
stop, a push stick must be used.
50. Important! The bandsaw is only intended for
home and DIY use. The machine is not designed
for professional use.
Pull out the power plug before
carrying out any repair or
maintenance work!
02.11.2005 8:49 Uhr Seite 19
Wear safety goggles
Wear ear-muffs
Wear a breathing mask

5. Technical data

Voltage:
Power:
Idle speed n o :
Blade length:
Blade width:
Blade speed:
Cutting height:
Throat:
Table size:
Tilting range of table:
Max. workpiece size:
Weight:

Noise emission values

LPA sound pressure level
LWA sound power level

6. Before starting the machine

Make sure the machine stands securely, i.e. bolt
it to a workbench or solid base. Fixing holes are
provided in the base plate for this purpose.
The saw table must be correctly assembled.
All covers and safety devices have to be
properly fitted before the machine is switched
on.
It must be possible for the blade to run freely.
When working with wood that has been
processed before, watch out for foreign bodies
GB
230V~50 Hz
740 W
-1
1400 min
2240 mm
6.5 -20 mm
370/800 m/min
5 -170 mm / 90°
70 mm / 45°
305 mm
520 x 400 mm
0° to 45°
600 x 600 mm
52 kg
Operation
92.7 dB(A)
102.3 dB(A)
19