Care And Cleaning; Disposal; Product - VOLTCRAFT KBM-700 Notice D'emploi

10. Maintenance
Calibrate the measuring probe each time it is replaced.
• The soaking bottles of ph electrode and redox probe should always be filled with soaking
solution to at least one third, so that the respective probe does not dry out. If necessary,
top up soaking solution. This soaking solution can be acquired under the Conrad order no.
1763048.
• The soaking bottle of the conductivity cell should always be filled to least one third with
distilled water so that this measuring probe does not dry out. If necessary, add distilled water.

11. Care and cleaning

Never use aggressive detergents, rubbing alcohol or other chemical solutions, as
these may damage the casing or stop the product from functioning properly.
• This product does not require any maintenance, except for changing the battery, cleaning/
replacing the measurement probes and replacing the used soaking solution. Do not attempt
to disassemble the product (except for the actions described in these instructions, such as
changing the measurement probes).
• Clean the product carefully using a soft, clean cloth. Do not press too hard on the display, as
this may result in scratch marks or damage its function.
• Only use distilled water (or deionized water) to clean the measurement probe tips. Using
other liquids may affect the measurements. Only use paper towels to dry the measurement
probes.

12. Disposal

a) Product
Electronic devices are recyclable waste and must not be placed in household waste.
At the end of its service life, dispose of the product according to the relevant statutory
regulations.
If a battery is inserted, remove it and dispose of it separately from the product.
37