Armrest Adjustment - Leckey Mygo Notice D'utilisation

10.20 Flat headrest
with lateral supports
To adjust the height, depth and angle of the
flat headrest, adjust using the hand levers (A),
as shown on the contoured head support.
To adjust the width of the laterals loosen
plastic knob (B), slide to desired position and
tighten securely.
10.21 Armrest
adjustment
To adjust the height of the armrest loosen
the hand knob (B), set to the desired height
and retighten. To adjust the angle, rotate
ratchet handle (A) until the desired position
has been achieved.
To remove the armrest completely, loosen
ratchet handle (C), press popper (D) and lift
the armrest.
Always use caution as fingers could
become trapped in the slot when
adjusting the height.
A
B
B
C
D