Using The Softkeys - Mettler Toledo SevenGo pro Mode D'emploi

Measurement modes
A single channel has to be selected first in order to switch the measurement mode (only SG98).
●
Press and hold the MODE key to switch between the dual and single channel measurement
screen (only SG98).
●
Press and release the MODE key in the single channel display to change between the different
mea s ure m ent modes.
The sequence of the alternating measurement modes for pH/ion measurement (only SG98) is:
1. pH
2. mV
3. rel. mV
4. ion
For the DO measurement the sequence is:
1. saturation (%)
2. ppm
3. mg/L
4.4 U sing the softkeys
The meter has three softkeys. The functions assigned to them change during operation depending
on the application. The assignment is shown on the bottom line of the screen.
In the measurement screen, the three softkeys are assigned as follows:
Menu
Access meter settings
The other softkey functions are:
Delete
16 Operating the pH/ORP/Ion/DO meter SG98 and DO meter SG9
51710917_V02.2011_BA_SG9_98_EnFrEs.indb 14
Save an endpointed mea s ure-
ment
Move one position to the right
Move one position to the left
Scroll up in the menu
Scroll down in the menu
Increase value
Decrease value
Scroll to next data set in mem-
o r y
Delete letters or numbers on
alphanu m er i c keypad
Delete selected data
Store
Access data menu
Edit Edit table or value
End End calibration
Yes Confirm
No Reject
Review Review selected data
Save Save data, setting or value
Select Select the highlighted function
or set t ing
Start Begin the reference mea s ure-
ment
Trans Transfer selected data
Data
21.04.2011 11:45:55