Dispenser Light; Door Alarm; Quick Ice - GE Profile 22 Manuel D'utilisation

About the ice and water dispenser.
Spill Shelf
16
To Use the Dispenser
Select CUBED, CRUSHED or WATER.
Press the glass gently against the top of the
dispenser cradle.
The spill shelf is not self-draining. To reduce
water spotting, the shelf and its grille should be
cleaned regularly.
If no water is dispensed when the refrigerator is
first installed, there may be air in the water line
system. Press the dispenser arm for at least two
minutes to remove trapped air from the water
line and to fill the water system. To flush out
impurities in the water line, throw away the first
six glassfuls of water.
CAUTION
Never put fingers or any other
objects into the ice crusher discharge opening.
Locking the Dispenser
Press the LOCK or LOCK CONTROLS pad for 3
seconds to lock the dispenser and control panel.
To unlock, press and hold the pad again for 3
seconds.

Dispenser Light

The LIGHT pad turns the light in the dispenser
on and off. The light also comes on when the
dispenser cradle is pressed. For models with a
bulb, if the light burns out, it should be replaced
with a 6 watt 12V maximum bulb. For LED
models contact Factory Service.

Quick Ice

When you need to speed up ice production, use the
Quick Ice feature. While this feature is turned on,
the freezer fan runs continuously for 48 hours, or
until the feature is turned OFF. During this period, ice
production will increase up to 40%. Models with the
integrated ice feature system require at FIRST USE at
least half an 8 oz. glass of ice to be dispensed every 6
to 12 hours. This will help the ice maker fill the bucket
properly so that dispensing is better.
(on some models)

Door Alarm

Use Door Alarm to sound if either door is open
for more than 3 minutes. The alarm will stop
once the door is closed. For LCD models, a popup
screen will appear. The alarm can be silenced by
touching the LCD screen.
Touch LED Dispenser Control:
Press the SET FEATURES pad once and DOOR
ALARM will blink. Press ON/OFF and the door
alarm will be set and the icon will turn solid. Press
ON/OFF again to turn the alarm off.
Door Alarm
model)
To set the alarm, press this pad until the indicator
light comes on. This alarm will sound if either
door is open for more than 3 minutes. The light
goes out and the beeping stops when you close
the door.
How to Use
Touch LED Dispenser Control:
Press the SET FEATURES pad twice and QUICK ICE
will blink. Press ON/OFF to turn the feature on, then
again to turn it off.
Quick Ice (on Tactile LED Dispenser Control
model)
When you need ice in a hurry, press this pad
to speed up ice production. This will increase
ice production for the following 48 hours or
until you press the pad again.
(on Tactile LED Dispenser Control