Use/Operation; Magnetic Smart Key; Battery Check/Setting On A New Machine; Battery Installation - Nilfisk Advance SC500 20D B Instructions D'utilisation

revised 07/2017

USE/OPERATION

WARNING!
On some points of the machine there are some adhesive plates indicating:
– DANGER
– WARNING
– CAUTION
– CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates (see Visible Symbols On
The Machine paragraph).
Do not cover these plates for any reason and immediately replace them if damaged.

MAGNETIC SMART KEY

A magnetic smart key (52) is required to start the machine. If the start switch (42) is pressed and the key is not in the key reader
(41), the display will turn on temporarily and it will show a key insertion request, then it will turn off.
There are two different magnetic smart keys:
1. User key (blue) for scrubbing/drying operations and basic information.
2. Supervisor key (yellow) for accessing additional features (see the Supervisor key paragraph in Maintenance chapter).

BATTERY CHECK/SETTING ON A NEW MACHINE

WARNING!
The electric components of the machine can be seriously damaged if the batteries are either improperly installed
or connected. The batteries must be installed by qualified personnel only.
Check the batteries for damage before installation.
Handle the batteries with great care.
The machine requires 2 12 V batteries, connected according to the diagram shown in Figure 1.
The machine can be supplied in one of the following modes:
Batteries already installed on the machine
1. Ensure that the battery connector (9) is connected.
2. When first using the machine with new batteries, perform a full charging cycle (see the procedure in Maintenance chapter).
Without batteries
1. Buy appropriate batteries (see "Technical Data" paragraph). For battery choice and installation, apply to qualified battery
Retailers.
2. Set the machine according to the type of batteries installed as shown in the Supervisor key section of the Maintenance
chapter.

BATTERY INSTALLATION

Battery Installation
1. Remove the user key (52).
2. Disconnect the battery connector (9).
3. Lift the cover (34) and check that the recovery tank (33) is
empty; if not, empty it using the drain hose (12).
4. Close the cover (34).
5. Grasp the handle (16) and carefully lift the tank (33).
6. The machine is supplied with cables suitable to install
2 12 V batteries. Carefully lift the batteries up to the
compartment, then install them correctly.
7. Route and install the battery cable as shown in Figure 1,
then carefully tighten the nut on each battery terminal.
8. Connect the battery connector (9).
9. Grasp the handle (16) and carefully lower the tank (33).
Battery Charging
10. Fully charge the batteries (see the procedure in
Maintenance chapter).
11/2014
INSTRUCTIONS FOR USE
Figure 1
9099980000 - SC500
ENGLISH
P100841
11