Responsibility Of The Operator - WIKA TR31-3 Mode D'emploi

3. Safety
up to 300 °C [572 °F]. It can be used for pressures up to 140 bar
[2,030 psi] with 3 mm [0.12 in] sensor diameters and up to 270 bar
[3,916 psi] with 6 mm [0.24 in] sensor diameters, dependent on the
EN
instrument version.
The instrument has been designed and built solely for the intended use
described here, and may only be used accordingly.
The technical specifications contained in these operating instructions
must be observed. Improper handling or operation of the instrument
outside of its technical specifications requires the instrument to be taken
out of service immediately and inspected by an authorised WIKA service
engineer.
The manufacturer shall not be liable for claims of any type based on
operation contrary to the intended use.

3.3 Responsibility of the operator

The system operator is responsible for selecting the thermometer
or protection tube, and for the selection of their materials, so as to
guarantee their safe operation within the plant or machine. When
preparing a quote, WIKA can only give recommendations which are
based on our experience in similar applications.
The safety instructions within these operating instructions, as well as the
safety, accident prevention and environmental protection regulations for
the application area must be maintained.
The operator is obliged to maintain the product label in a legible
condition.
WIKA operating instructions models TR31-3, TR31-K 9