Layout And Items Supplied - EINHELL GH-PM 51 S HW Mode D'emploi D'origine

Masquer les pouces Voir aussi pour GH-PM 51 S HW:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 40
the ground a little in order to start it. In this
case, tilt it as little as absolutely necessary
and only raise the side opposite to that of the
user.
15. Do not start the engine if you are positioned in
front of the chute.
16. Never move your hands or feet toward or un-
der any rotating parts. Keep clear of the chute
opening at all times.
17. Never lift or carry a lawn mower with the engi-
ne running.
18. Pull out the ignition key and spark plug boot.
- before you dislodge any blockages or clogs
in the chute.
- before carrying out any checks, cleaning,
maintenance or other work on the lawn mo-
wer.
- if you have struck a foreign object. Examine
the mower for signs of damage and carry out
any necessary repairs before restarting and
continuing to work with the mower. If the lawn
mower begins to experience exceptionally
strong vibrations, immediately switch it off
and check it.
- when you leave the lawn mower.
19. Switch off the engine and make sure that the
blade and all moving parts have come to a
complete standstill.
- before you refuel.
20. When you switch off the engine, move the
throttle lever to the „Stop" position. Close the
petrol cock (if fi tted).
21. Operating the equipment at excessive speed
may increase the risk of accidents.
22. Carry out adjustment work on the equipment
with care and avoid jamming your fi ngers bet-
ween the moving blades and rigid parts of the
equipment.
Maintenance and storage
1. Make sure that all nuts, bolts and screws are
tightened securely and that the equipment is
in safe working condition.
2. Never store the mower (with petrol in the
tank) inside a building in which petrol fumes
could come into contact with open fl ames or
sparks.
3. Allow the engine to cool before you put the
lawn mower in an enclosed area.
4. In order to avoid fi re hazards, keep the engi-
ne, exhaust and the area around the fuel tank
free from grass, leaves and leaking grease
(oil).
5. Routinely check the grass basket for signs of
wear and impaired functionality.
Anl_GH_PM_51_S_HW_SPK7.indb 28
Anl_GH_PM_51_S_HW_SPK7.indb 28
GB
6. For your own safety, replace worn or dama-
ged parts without delay.
7. If the fuel tank needs to be emptied, ensure
that it is done out in the open with a petrol
suction pump (available from DIY stores).
Caution!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Explanation of the warning signs on the
equipment (see Fig. 13)
1) Read the operating instructions.
2) Take care of the danger from catapulted
parts. Keep a safe distance.
3) Caution! Sharp blades - Switch off the engine
and pull the spark plug boot before doing any
maintenance, repair, cleaning or adjustment
work.
4) Fill with oil and fuel before starting the mower.
5) Caution: Wear ear protection and safety gog
gles.
6) Engine start/stop lever (I=Engine on; 0=Engi-
ne off )
7) Drive lever (clutch lever)
8) Risk of cut injuries. Caution: rotating cutters.

2. Layout and items supplied

2.1 Layout (Fig. 1-12)
1a. Motor start/stop lever (motor brake)
1b. Control lever (clutch control)
2. Throttle control
3. Top and bottom push handle
4a. Grass basket
4b. Side ejector adaptor
4c. Mulching adaptor
5a. Ejector fl ap
5b. V-belt
5c. Side ejector fl ap
6. Tank fi ll cap
7a. Oil fi ller screw
7b. Oil drainage screw
8. Cutting height adjustment
9. Starter cable
10. Cable clip (1x)
11. Star nut (4x)
12. Screw (4x)
13. Spark plug wrench
- 28 -
05.09.13 14:31
05.09.13 14:31

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

34.045.10

Table des Matières