Safety Hints - Dörr STUDIO BLITZ SEMI DFX-250 Notice D'utilisation

GB | INSTRUCTION MANUAL
THANK YOU for choosing this DÖRR quality product.
Please read the instruction manual and safety hints carefully before first use.
Keep this instruction manual together with the device for future use. If other people use this device, make this instruction manual
available. This instruction manual is part of the device and must be supplied with the device in case of sale.
DÖRR is not liable for damages caused by improper use or the failure to observe the instruction manual and safety hints.
01 |

SAFETY HINTS

·
Do not trigger the studio flash directly in front of the eyes of humans or animals. This may cause an irreversible damage to the
retina. Keep a minimum distance of 2,5 m and make sure that people or animals do not look directly into the studio flash.
·
The flash tube and the modelling light produce high temperatures, which is also transferred to the reflector. While operation never
touch the ignition wire, the flash tube, the modelling light and the reflector – risk of burns and of electric shock!
·
Do not touch the modelling light and the flash tube with bare hands. Greasy fingerprints may cause the bursting of the lamps during
operation! Wear thin gloves e.g. made of cotton or microfiber or use a cloth for inserting or replacing the lamps.
·
Cool down the studio flash before making any installations or before you store it.
·
Make sure that the studio flash is mounted stable and secure and cannot tip over. Risk of fire!
·
Only operate with the supplied original cables. Do not use an extension cord. Take care that that nobody stumbles over the cable
connections.
·
Keep away from flammable materials.
·
The modelling light is only designed to illuminate the object while the camera settings are made. It is not suited as a permanent
light since it produces high temperatures which can harm flash accessories like conical snoots, softboxes, honeycombs or others
(risk of melting).
·
Only for photographic purposes. Not suited for permanent room lightning.
·
If you notice a smell of burning, switch off the studio flash immediately at the main switch and disconnect from power. Risk of fire!
Please contact your dealer.
·
Do not touch or operate the device with wet hands or when standing on wet floor.
·
Ensure sufficient ventilation during operation. Never cover the ventilation slots.
·
After use turn of the device at the main switch and disconnect from power source.
·
Inside the studio flash may occur high voltage. Do not attempt to repair the device by yourself. Risk of electric shock! When service
or repair is required, contact qualified service personnel.
·
Protect the device against impacts. Do not use the device if it has been dropped. In this case a qualified electrician should inspect
the device before you use it again.
·
Protect the device from rain, moisture, direct sunlight and extreme temperatures.
·
Do not use the device nearby devices that generate strong electromagnetic fields.
·
People with physical or cognitive disabilities should use the device with supervision.
·
People with cardiac pacemakers, defibrillators or any other electrical implants should maintain a minimum distance of 30 cm, as
the device generates magnetic fields.
·
This device is not a toy. To prevent accidents and suffocation keep the device, the accessories and the packing materials away from
children and pets.
·
Protect the device against dirt. Never use aggressive cleansing agents or benzine to clean the device. We recommend a soft, slightly
damp microfiber cloth to clean the outer parts of the device. Make sure to take off the device from power before cleaning!
·
Store the device in a dust-free, dry and cool place.
·
If the device is defective or without any further use, dispose of the device according to the Waste Electrical and Electronic
Equipment Directive WEEE. For further information, please contact your local authorities.
12 doerr-foto.de