Change Daily Heating / Cooling Periods - Siemens RMU7-B Série Manuel D'utilisation

Change daily heating / cooling periods

General
In the time switch program, you can set the daily heating
and cooling periods to suit your individual needs.
Each day can accommodate a maximum of 6 switching
points; a room setpoint is assigned to each time period.
In addition to the weekdays (Monday through Sunday),
you can program a special day, that is, a special 24-hour
heating and cooling program.
The special day is activated when you make an entry in
Holidays ( page 16).
Changes on the controller are possible only if the con-
troller's time switch defines the program.
If an external operator station controls the program,
changes can only be made from that station.
14
Building Technologies / HVAC Products
Path: Welcome > Main menu > Time switch... > ...
CE1B3144x2
Observe the following prior to making entries:
• First enter the start time for the heating/cooling phase
and then the room operating mode for the phase.
• The following room operating modes
available. Set the corresponding setpoints in menu
Controller 1 and Controller 2 (
• You can copy any 24-hour heating / cooling program
to other days ( page 15).
Change and delete times and setpoints
1. Select the required day.
2. In the diagram, advance the pointer
be changed.
3. Set the desired time.
Delete the time: Reset the time via 00:00 until ––:––
appears.
4. Select the desired operating mode.
5. If required, set additional times and select additional
setpoints.
74 319 0350 0a
, , and are
page 12 und 13).
to the time to
31.01.2007