Choose Password; Change Password; Programming Commands - Siemens Codelock K44 Duo Manuel D'installation Et D'utilisation

K44 Duo Installation & User manual

Choose password

The first thing to do before you can start program-
ming is to choose a password.
1� Press and hold the SW1 button on the code
lock's circuit board. Both LEDs are lit.
2� Enter a 6-digit password.
3� Make a note of the new password in the chart at
the back of the manual.

Change password

1� Press B and enter the current password.
2� Enter A27.
3� Enter the new password. A warning tone is
heard.
4� Enter the new password once again.
5� Press B to leave programming mode.
6� Make a note of the new password in the chart at
the back of the manual.

Programming commands

Always press B and the password before any com-
mands are used.
Leaving the programming mode can be done by
pressing B.
11