General Safety Notes; Electrical Safety - Miele PTD 701 Notice D'utilisation

3 Safety notes
Miele assumes no liability or warranty in the event of non-compliance with these safety
and operating instructions.

3.1 General safety notes

 Read the safety notes and operating instructions carefully.
 Retain the quick guide for future reference.
 Only use the warewasher after you have read and understood the quick guide and the
safety notes.
 Ask the Miele Customer Service Department to provide information about the operation
and functioning of the warewasher.
 Train the operating personnel appropriately regarding handling the machine and refer
them to the safety notes. Repeat the training sessions at regular intervals to prevent ac-
cidents.
 Do not climb or sit on the opened hinged door.
 Operate this machine only when it is in perfect condition.
 A damaged or leaking machine may endanger your safety. In the event of defects,
switch off the machine immediately. Switch the machine on again only when the defect
has been remedied. Switch off the on-site mains switch. Only then is the machine com-
pletely disconnected from the electricity supply.
 Contact your installer or electrician if the on-site water or electricity supply is the cause
of a malfunction.
 If another fault occurs, notify an authorised service technician or your dealer.
 At the end of the working day, close the on-site water tap.
 At the end of the working day, switch off the on-site mains disconnector.

3.2 Electrical safety

 The electrical safety of this machine is guaranteed only if it is connected to a correctly
installed protective circuit and a residual current circuit breaker. It is crucial that these
basic safety requirements are tested and, in case of doubt, have the on-site installation
checked by a qualified electrician.
Miele cannot be held responsible for damage caused by a missing or defectice protec-
tive conductor (e.g. electrical shock).
 Do not open any machine covers or machine parts if doing so requires tools. There is a
risk of electric shock.
 For your safety, test the on-site residual current circuit breaker (FI) regularly by pressing
the test button.
3.3 Maintenance and repair work
 Maintenance work and repairs may only be carried out by authorised Miele service
technicians. Improper maintenance or repairs may cause significant danger to the user,
for which Miele is not liable.
 When carrying out installation and maintenance work, unplug the machine from the
mains supply. Electrical elements of the machine contain voltage until disconnected
from the mains supply.
 Only original Miele spare parts may be used for maintenance and repairs. If original
spare parts are not used, the warranty is invalidated.
 If the mains cable of this machine is damaged, it must be replaced by Miele or its Cus-
tomer Service or another qualified person in order to prevent hazards. The mains cable
must be an H07 RN-F type or equivalent.
Safety notes
45