Fcc/Ce Warning; Declaration Of Conformity - Philips WelcomeEye Connect DES9900VDP - 531002 Notice D'utilisation

maintain this status and get the most out of the product, users must adhere to the safety
instructions and warnings contained in this manual.
: This symbol indicates that there is a risk of electric shock or short-circuit.
- You should only use this product with a voltage between: 100-240 Volts and 50-60 hertz.
Never attempt to use this device with a different voltage.
- Ensure that all the system's electrical connections conform to the instructions for use.
- In commercial establishments, ensure that you adhere to the electrical installation
accident prevention regulations.
- In schools, training facilities, workshops, etc. qualified personnel must be on hand to
monitor electronic equipment operation.
- You must follow the instructions for use of any other devices connected to the system.
- Please contact an experienced person if you have any doubts regarding equipment
operation or safety.
- Never plug in or unplug electrical equipment with wet hands.
- When installing this product, check that the power supply cables are not at risk of being
damaged.
- Never replace damaged electrical cables yourself! In this case, remove them and call an
expert.
- The mains supply should be located close to the device and must be easily accessible.
- An easily accessible cut-off system (switch disconnector, circuit breaker, equivalent
system) must be integrated into the building's wiring installation for the equipment
connected to the power grid.
- Keep a minimum distance around the device to guarantee sufficient ventilation.
- Ventilation should not be blocked by covering the ventilation opening with an object such
as a newspaper, tablecloth or curtain, etc.).
- No open flame source such as a burning candle must be placed on the device.
- Respect the product's operating temperature.
- The device must not be exposed to liquid flow or splashing. Do not place any objects filled
with liquid such as vases on the device.

14. FCC/CE WARNING

Note:
This equipment has been tested and found to comply with the limits for the Class
B, in compliance with current European safety standards. These limits are designed to
provide reasonable protection against interference in a residential installation. This
equipment uses and emits a radio frequency energy and may cause interference with
radio communications if not installed and used according to the instructions.
However, there is no guarantee that there will be zero interference in any given
installation. If this equipment causes interference with radio or TV reception, which can
be determined by starting and stopping the equipment, we recommend resolving this
interference by using at least one of the following measures:
• Reorient or move the receiving antenna
• Increase the distance between the equipment and the receiver
• Use a plug on a different circuit to that being used by the receiver

15. DECLARATION OF CONFORMITY

The undersigned, CFI-Extel, declares that the WelcomeEye radioelectric equipment
complies with the 2014/53/EU directive. The full text of the EU declaration of conformity
is available at the following address: www.cfi-extel.com.
WelcomeEye Connect / Touch / 09/17
GB28