Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
UK
DANGER:
ATTENTION:
3.9. Machine Data and Technical features
3.9.1. Identification Plate
In order to identify the machine a CE identification tag has been attached to it; the identifying data included on this tag must be
reported to the Manufacturer at every service request or when ordering replacement parts. It is located near the condensing unit
(Figure 2). Specifically, the following data is included on the identification tag:
code,
serial number,
amps (A),
watts (W),
refrigerant type,
supply voltage (Volt/Ph/Hz),
maximum operating pressure PS HP (high pressure side) - PS LP (low pressure side),
maximum operating pressure TS HP (high pressure side) - TS LP (low pressure side),
assembly category according to Directive 97/23/EC (PED)
Serial number identification
numbers 1 and 2 = last two numbers of the year built,
numbers 3 and 4 = week of the year in which the machine was produced,
numbers 5, 6, 7 and 8 = progressive number
Figure 2 - Position of the CE identification tag.
3.10. Technical Data and Overall Dimensions
The technical features of the machine are found in Chapter 9 – Attachments in this handbook.
4
.
T
r
a
n
s
p
o
r
t
4
.
T
r
a
n
s
p
o
r
t
4.1. General information
The installation and possible re-installation of the machine must be conducted directly by qualified staff.
Before proceeding to installing the machine, it is necessary to prepare the power supplies and utilities necessary for the correct
functioning of the system, following the indications reported in this chapter and, if necessary, consulting the manufacturer's Technical
Office in advance.
ATTENTION:
DANGER:
tampering or unauthorised replacement or one or more parts of the machine and use of accessories, tools
or consumable materials other than those indicated by the manufacturer can generate danger of injury.
all the materials with environmental impact which must be eliminated after interventions or processes on the
machine must be disposed of according to norms in force. If necessary, entrust specialist structures to
dispose of them.
a
n
d
I
n
s
t
a
l
l
a
t
i
a
n
d
I
n
s
t
a
l
l
a
t
This product as sold complies with the 97/23CE (PED) standard and is marked with the relevant category.
After purchase it is the responsibility of the owner to ensure that this equipment is regularly maintained
continue its compliance up to the stage when it is finally decommissioned according to the relevant national
law.
the manufacturer declines all responsibility for any damage to property and/or persons deriving from
improper interventions conducted by unqualified, untrained or unauthorised staff.
o
n
i
o
n
LABEL
FS Pag. 45 Rev 00 02/11
Publicité
Chapitres
Table des Matières
