WAGNER PAINT CREW Mode D'emploi page 20

P P
URGING AND RIMING THE
1. Make sure the inlet filter is in
place inside the hopper. If it is
not, snap in place as shown.
2. Push the tab on top of the
filter down once. This will
ensure proper operation of
the inlet valve.
3. Pull the return tube from the
hopper and hold it over a
waste container.
4. Turn the PRIME/SPRAY
knob to PRIME.
5. Plug in the sprayer, and move the ON/OFF
switch to the ON position.
Any fluids remaining in the pump and
the return tube will flow out of the
return tube. Let the pump run until no
fluid is coming from the return tube.
6. Switch the pump to OFF. Remove the return
tube from the waste container and secure it to the hopper.
7. Fill your hopper with the
material you plan to spray.
Do not exceed the fill line
as shown. Replace the
hopper lid.
8. Leave the PRIME/SPRAY
knob on PRIME and switch
your unit ON once more
and make sure that
material is flowing from the
return tube.
P
URGING AND
Your sprayer is now purged. Move to Purging and
Priming the Spray Hose.
English
P
URGING AND
P
UMP
Tab
Fill line
P
RIMING
P S
RIMING THE PRAY
1. Unlock the spray gun and turn
the PRIME/SPRAY knob to
PRIME.
Your spray tip SHOULD
NOT be attached to your
spray gun when purging
your spray hose.
2. Trigger and HOLD the spray
gun into a waste container
WARNING
If the PRIME/SPRAY knob is still on SPRAY,
there will be high pressure in the hose and
spray gun until the PRIME/SPRAY knob is
turned to PRIME.
3. While holding the trigger, switch the pump ON.
4. While holding the trigger, turn
the PRIME/SPRAY knob to
SPRAY. Hold the trigger until all
air, water, or solvent is purged
from the spray hose and paint
is flowing freely (read warnings
below).
WARNING
Keep hands clear from fluid stream.
5. Release trigger, turn the
PRIME/SPRAY knob to PRIME
and turn pump OFF .
6. Trigger the gun into the waste
container once more to be
sure that no pressure is left in
the hose.
7. Lock the spray gun off.
8. Thread the spray tip assembly onto the gun. Tighten by
hand.
Begin
tightening
the tip at
this angle
Your hose is now purged and primed.
20 20 20 © 2007 J. Wagner GmbH - All rights reserved. © 2007 J. Wagner GmbH - All rights reserved.
H
OSE
SPRAY
to achieve
the desired
spray angle
when tight.
All rights reserved.