Options - Crutch Holder; Options - Therapy Table; Options - Stabilising Bar; Options - Headrests - Quickie HeliX2 Notice D'utilisation

Options – Crutch holder
CRUTCH HOLDER
This device permits crutches to
be transported directly on a
wheelchair. It has a Velcro
loop to fasten crutches or other
aids, (Fig.52).
WARNING!
Never try to use or remove the
crutches or other aids while
moving.

Options - Therapy table

THERAPY TABLE
The tray provides a flat surface
for most activities. Before
using a tray, it first has to be
adjusted to the width of the
seat by an authorised dealer.
The user must be sitting in the
wheelchair during this
adjustment, (Fig.53).
Options – Stabilising bar
SWING AWAY STABILISING BAR
This bar is used to stabilise the backrest. To be able to fold the
wheelchair, the release lever (1) must be pushed inwards and the
stabilising bar must be flipped downwards.
When unfolding the wheelchair, please make sure that the
stabilising bar is locked into position, (Fig.54).
Fig. 54
FOLDING STABILISING
BAR
This bar is used to stabilise the
backrest. To be able to fold the
wheelchair, the stabilising bar
must be pushed downwards in
the middle (1). To completely
unfold the wheelchair, the
carrying handle (2) must be
pulled upwards, (Fig.55)
Fig. 52
Fig. 53
1
Fig. 55
1
Options – Headrests
HEADRESTS
The headrest can be raised and
moved both forwards and
backwards. To do this, simply
loosen the screw (1 or 2), adjust
the headrest to the desired
position and tighten the screw
(see the section on torque),
(Fig.56).
COMFORT HEADREST
To adjust the height open the
star knob (3) and move the
headrest into the right position.
Please re-tighten the star knob,
(Fig.57).
Options – Transit wheels
TRANSIT WHEELS
Transit wheels should be
used wherever your
wheelchair would be too wide
if the rear wheels were used
(e.g., in airplanes, buses,
etc.). After the rear wheels
have been removed with the
aid of the quick-release axles,
the transit wheels can
immediately be used to
continue riding. The transit
wheels are mounted so that
they are approx. 3 centimeters above the ground when not in use.
They are thus out of the way when riding, transporting or when
tipping to pass over obstacles (e.g., kerbs, steps, etc.) (Fig. 58).
DANGER!
Your wheelchair does not have any wheel locks when the transit
wheels are being used.
Options – One-hand operation
ONE-HAND OPERATION
To move the wheelchair in a
2
straight line, both hand wheels
must be operated. If the
wheelchair is to be folded up,
remove the pull-off bar by
pushing it inwards, (Fig.59).
WARNING!
To avoid injury, always make
sure that all connections are
firmly in place.
Fig.56
1
Fig. 57
3
Fig. 58
Fig. 59
HeliX
2
2
19