Settings; Working - Festool CLEANTEX CT 26 E Guide D'utilisation

Consider the pictures on the fold-out page.
Connecting electric power tools
WARNING
Risk of injury
Observe the maximum connected loads for the
appliance socket (see chapter "Technical data").
Make sure that the power tool is switched off be-
fore connecting or disconnecting.
Connect the electric power tool to the appliance
socket [1-3].
Connecting pneumatic tools
WARNING
Risk of injury
Make sure that the pneumatic tool is switched
off before connecting or disconnecting.
If the compressed air module [1-2] (496141) is in-
stalled, the automatic switch-on function of the
mobile dust extractor also works in combination
with pneumatic tools.
Handling
Hose store: after finishing work, you can feed the
suction hose through the recess [4-3] and place it
in the hose store. You can do the same with the
mains cable through the other recess [4-2].
SysDoc Systainer attachment system: a Systainer
can be attached to the storage area via the two
slides [4-1].
10

Settings

We also recommend installing the VE service unit
(495886). The service unit filters and lubricates the
compressed air and enables an adjustment of the
air pressure. An IAS adapter (454757) is available to
connect Festool pneumatic tools to the IAS system.
The operating pressure of the tool must be 6 bar for
the automatic switch-on unit to function correctly.
Temperature cut-out
To prevent overheating, a temperature cut-out
switches the mobile dust extractor off when it
reaches a critical temperature.
Switch off the mobile dust extractor and allow to
cool for about 5 minutes.
If the mobile dust extractor will not switch on
again, please contact a Festool service work-
shop.
Adjusting the suction power
You can use the suction power adjuster [1-7] to
adapt the machine suction power to different appli-
cations.
Folding out the brake lever [1-12] prevents the mo-
bile dust extractor from rolling. To achieve this, lift
the front end of the mobile dust extractor slightly
and push the brake lever downwards until it latches
into place. Push the lever [1-11] again to release.

Working

4
4-1
Applying the brake
4-2
4-3