Operation; Extension Cord; Switch On/Off; Settings - Festool CT 36 E AC HEPA Notice D'utilisation D'origine

WARNING
The user will be liable for damage due to im­
proper use.
7

Operation

WARNING
Unauthorised voltage or frequency!
Risk of accident
► The mains voltage and the frequency of the
power source must correspond with the
specifications on the machine's name
plate.
► In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
may be used.
Consider the pictures on the fold-out page.
7.1 Initial operation
► Open the locking clips [2-2] and remove the
top section of the machine [2-1].
► Remove the accessories from the dust con­
tainer [2-3] and the packaging!
► Insert a filter or disposal bag in the dirt trap
(see chapter and ).
► Replace the top section [2-1] and close the
locking clips [2-2].
3
► Attach the cable holder to the rear of the
mobile dust extractor (see Fig. [3]).
► Connect the suction hose to the machine.
7.2

Switch on/off

► Insert the plug into an earthed socket.
CAUTION
Risk of injury from tools starting up unex­
pectedly
► Before setting the switch to the "AUTO" or
"MAN" position, make sure that the con­
nected tool is switched off.
The switch [1-9] serves as an on/off switch.
Switch position "0"
Appliance socket is disconnected from the
power, mobile dust extractor is switched off.
"MAN" switch position
Appliance socket is connected to the power,
the mobile dust extractor starts.
"Auto" switch position
Appliance socket is connected to the power,
the mobile dust extractor starts when the con­
nected tool is switched on.
7.3

Extension Cord

If an extension cord is required, it must have
sufficient cross-section to prevent an excessive
drop in voltage or overheating. An excessive
drop in voltage reduces the output and can lead
to failure of the motor. The table below shows
you the correct cord diameter as a function of
the cord length for this tool.
Total Exten­ 25
sion Cord
Lenght
(feet)
Cable size 14
(AWG)
Use only U.L. and CSA listed extension cords.
Never use two extension cords together. In­
stead, use one long one.
The lower the AWG number, the stronger
the cord.
7.4 The antistatic system
Friction inside the extraction hose causes static
electricity to develop during extraction. Operat­
ing personnel may receive unpleasant electric
shocks while working. The mobile dust extrac­
tor is fitted with an antistatic system as stand­
ard to discharge any static electricity that may
develop. However, always use the enclosed an­
tistatic extraction hose.
8

Settings

Consider the pictures on the fold-out page.
English
50 100 150
12 not recom­
mended
11