Filter; Changing The Filter Bag - Festool CT 36 E AC HEPA Notice D'utilisation D'origine

English
► Use kink-resistant suction hose D 36 mm x
3.5 m-AS.
► Use a special suction sleeve for connecting
the PLANEX.
► Use closing slide CT-VS between the intake
opening [1-1] and suction hose.
► Attach the tool holder.
► Always use with a disposal bag!

10 Filter

WARNING
Risk of injury
► During the following procedure, take care
not to raise dust more than is unavoidable.
Moisten the main filter with a water spray
before removing it.

10.1 Changing the filter bag

Inserting the filter bag
► Open the locking clips [2-2] and remove the
top section of the machine [2-1].
► Insert a new filter bag (FIS-CT 26/36) (Fig. ).
Important: push the filter bag socket firmly
onto the inlet fitting.
Make sure that the filter bag is not pinched
between the top and bottom sections.
2
5
► Replace the top section [2-1] and close the
locking clips [2-2].
Removing the filter bag
► Open the locking clips [2-2] and remove the
top section of the machine [2-1].
14
1
3
► Remove the filter bag (Fig. ).
► Dispose of the used bag in accordance with
statutory regulations.
► Clean the dust container [2-3].
► Insert a new filter bag if necessary (see ).
2
6
► Replace the top section [2-1] and close the
locking clips [2-2].
10.2 Changing the disposal bag
Inserting the disposal bag [7]
► Open the locking clips [2-2] and remove the
top section of the machine [2-1].
ENS-CT 26/36/48
2
7
► Insert a new disposal bag (ENS-CT26/36) on
the inlet nozzle of the container and lock in
position.
1
3
1
3
7-1