Changing The Filter Element; Accessories; Disposal; Warranty - Festool CLEANTEX CT 26 E HEPA Notice D'utilisation D'origine

CLEANTEX
GB
X
Clean the dust container [2-3].
X Replace the top section
the locking clips [2-2].
9.3

Changing the filter element

NOTE
Motor damage
X
Never operate the extractor without a fil-
ter element fitted as the motor may be-
come damaged.
X Open the locking clips
the top section of the machine[2-1].
X
Turn the top section of the machine so
that the main filter is facing upwards
(Fig.[9]).
X
Fold over the lever
retainer. [9-2]
X
Remove the used main filter and replace
[9-1] with a new one.
X Dispose of the used filter in accordance
with statutory regulations.
X Insert the retainer
lever [9-3] until it engages.
X
Replace the top section
the locking clips [2-2].
9.4 Emptying the dust container
The dust container
once the top section has been removed.
X After extracting fluids, clean the fill level
sensors [10-1] regularly with a soft cloth
and inspect for damage.
10

Accessories

Use only original Festool accessories and
Festool consumable material intended for
this machine because these components are
designed specifically for the machine. Using
accessories and consumable material from
other suppliers will most likely affect the
quality of your working results and limit any
warranty claims. Machine wear or your own
personal workload may increase depending
on the application. Protect yourself and your
machine, and preserve your warranty claims
by always using original Festool accessories
and Festool consumable material!
The order numbers for the accessories and
filters can be found in the Festool catalogue
or on the Internet at "www.festool.com".
16
[2-1] and close
[2-2] and remove
[9-3] and remove the
[9-2] and fold over the
[2-1] and close
[2-3] can be emptied
10.1 Modules
The following modules for upgrading the mo-
bile dust extractor are available in the acces-
sories programme. Modules must be fitted to
the module slot [1-2]
vice workshop:
– Compressed air module,
– Socket module with permanent power sup-
ply,
– Socket module with automatic switch-on
unit (not suitable for GB 110 V version),
– Energy box module (EAA) for using the au-
tomatic switch-on unit on the EAA.
You can find more detailed information on
the modules at "www.festool.com".
11

Disposal

Do not throw the tool in your household
waste!! Dispose of machines, accessories
and packaging at an environmentally re-
sponsible recycling centre. Observe the valid
national regulations.
EU only: European Directive 2002/96/EC
stipulates that used electric tools must be
collected separately and disposed of at an
environmentally responsible recycling cen-
tre.
12

Warranty

We offer a warranty for material and produc-
tion defects for all our tools in accordance
with the locally applicable legal provisions,
but for a minimum of 12 months. Within the
EU member states, the warranty period is 24
months (verification through invoice or deliv-
ery note). Damage caused by the operator,
natural wear, overloading, incorrect handling
or through the use of the equipment not
specified in the operating manual, or damage
which was known at the time of purchase, is
not covered by the warranty. Furthermore,
damage caused by the use of non-original
accessories and consumable materials (e.g.
sanding pads) is also excluded.
Complaints can only be accepted if the tool is
returned while still assembled to the supplier
or an authorised Festool Customer Service
workshop. Keep the operating manual, safe-
ty instructions, spare parts list and purchase
receipt in a safe place. Otherwise the current
warranty conditions of the manufacturer
shall apply.
by an authorised ser-