After Finishing Work; Service And Maintenance - Festool CLEANTEX CT 26 E HEPA Notice D'utilisation D'origine

The dust extractor stops automatically when
the maximum level is reached.
CAUTION
Escaping foam and fluids
X Switch off the machine immediately and
empty the dirt trap.
8.4 The antistatic system
Friction inside the extraction hose causes
static electricity to develop during extraction.
Operating personnel may receive unpleasant
electric shocks while working. The mobile
dust extractor is fitted with an antistatic sys-
tem as standard to discharge any static elec-
tricity that may develop. However, always
use the enclosed antistatic extraction hose.
8.5

After finishing work

X Switch off the mobile dust extractor and
disconnect the plug.
X
Wind up the mains power cable.
X
Empty the dust container.
X Place the mobile dust extractor in a dry
room inaccessible to unauthorised users.
9

Service and maintenance

WARNING
Risk of injury, electric shock
X
Always disconnect the mains plug from the
socket before performing maintenance
work on the machine!
X
All maintenance and repair work which re-
quires the motor housing to be opened
must only be carried out by an authorised
service workshop.
A dust test must be performed at least once
a year by the manufacturer or an instructed
person. This test may include checks to de-
termine whether the filter is damaged, the
machine is sealed properly and the monitor-
ing features are functioning correctly.
During maintenance and repair work, all
components that cannot be cleaned satisfac-
torily must be replaced. The old components
must be sealed in impermeable plastic bags
prior to disposal in compliance with applica-
ble regulations for this type of waste.
Damaged safety devices and components
must be repaired or replaced in a recognised
specialist workshop, unless otherwise indi-
cated in the operating manual.
9.1 Changing the filter bag (FIS-CT
26/36)
Inserting the filter bag
X
Open the locking clips
the top section of the machine[2-1].
X
Insert a new filter bag (FIS-CT 26/36) in
the inlet port of the dust container and in-
terlock it. Important: be aware that the
locking engages.
X
Replace the top section
the locking clips [2-2].
L Make sure that the filter bag is not
pinched between the top and bottom sec-
tions.
Removing the filter bag
X
Open the locking clips
the top section of the machine[2-1].
X Remove the filter bag.
X
Dispose of the used filter bag in accor-
dance with statutory regulations.
X
Replace the top section
the locking clips [2-2].
9.2 Changing the disposal bag
Inserting the disposal bag
X Open the locking clips
the top section of the machine[2-1].
X Insert a new disposal bag (ENS-CT26/36)
on the inlet nozzle of the container and
lock in position.
Important: The lateral openings on the
disposal bag must be positioned inside the
container. Make sure that the bolt engag-
es.
X Place the disposal bag over the edge of
the container.
Make sure that the contacts
free.
X
Replace the top section
the locking clips [2-2].
Removing the disposal bag
X
Open the locking clips
the top section of the machine[2-1].
X Close the disposal bag.
X
Remove the disposal bag.
X
Dispose of the used disposal bag in accor-
dance with statutory regulations.
CLEANTEX
GB
[5]
[2-2] and remove
[2-1] and close
[6]
[2-2] and remove
[2-1] and close
[7]
[2-2] and remove
[10-2] are
[2-1] and close
[8]
[2-2] and remove
15