Working; After Finishing Work; Service And Maintenance - Festool CTL 26 E Notice D'utilisation D'origine

Automatic cleaning
Adjust the frequency using the rotary knob
[1-7].
Only CTL for 36 E AC-LHS: switch on using the
rotary knob [1-7].
Manual cleaning
Turn the switch [1-8] to the AC symbol.
Full manual cleaning
► Cover the end of the nozzle or suction hose
with your hand or closing slide CT-VS
(497926) for 2 seconds.
► Turn the switch [1-8] to the AC symbol.

8 Working

8.1 Handling
Hose store: after finisching work, you can feed
the suction hose through the recess [8-2] and
place it in the hose store.
SysDoc Systainer attachment system: a Sys­
tainer can be attached to the storeage area via
the four slides ore the T-Loc [8-1].
8.2 Extracting dry materials
CAUTION
Hazardous dust
Damage to the respiratory passage
► Always use a filter or disposal bag!
When extracting dust that exceeds the
permitted limit values, only extract from
a single machine (electric or air tool).
Observe the following when extracting dust
generated by operating electric power tools:
Ensure there is adequate ventilation! Observe
regional regulations!
Limit values: exhaust air max. 50% of the clear
air volume
Formula: room volume V
8.3 Extracting wet materials/liquids
Remove the filter or disposal bag!
Recommendation: use special wet filter
(NF-CT).
The dust extractor stops automatically when
the maximum level is reached.
After wet extraction, allow the main filter to dry!
x air renewal rate L
R
Escaping foam and fluids
► Switch off and empty the machine immedi­
ately.
8.4

After finishing work

► Only versions with AutoClean: Clean the
main filter automatically or manually (see
chapter 7.3
► Switch off the mobile dust extractor and
pull out the mains plug.
► Wind up the mains power cable.
► Empty the dirt trap.
► Place the mobile dust extractor in a dry
room inaccessible to unauthorised users.

9 Service and maintenance

Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing maintenance
work on the machine!
► All maintenance and repair work which re­
quires the motor housing to be opened
must only be carried out by an authorised
service workshop.
Customer service and repair only through
manufacturer or service workshops: Please
find the nearest address at: www.festool.com/
service
EKAT
4
W 5
3
2
1
Only use original Festool spare parts! Order No.
at: www.festool.com/service
► Clean the level sensors [5] and empty the
dirt trap [1-11] regularly.
Observe the following instructions:
– The manufacturer or an instructed person
must perform a dust test at least once a
year to determine whether the filter is
damaged, the machine is sealed properly
CAUTION
).
WARNING
English
15