Working; Service And Maintenance - Festool CTL 26 E Notice D'utilisation

English
Not possible to switch on: contact Festool
service workshop.
7.5 AutoClean – cleaning the main filter
(variants with AutoClean only)
Only in conjunction with a disposable
bag (to comply with dust class "L"). Not
for use during wet extraction.
Automatic dedusting
Activate AutoClean or set the frequency using
the rotary knob [1-7] (depending on the mobile
dust extractor variant).
Manual dedusting
Turn the switch [1-8] to the AC symbol.
Full manual cleaning
► Cover the end of the nozzle or suction hose
with your hand or CT-VS closing slide for
two seconds.
► Turn the switch [1-8] to the AC symbol.
8

Working

8.1 Handling
Hose holder: After finishing work, you can feed
the suction hose through the opening [8-2] and
place it in the hose holder.
SysDoc Systainer storage area: A Systainer can
be fastened to the storage area with the four
slides or the T-Loc lock [8-1].
8.2 Extracting dry materials
CAUTION
Hazardous dust
Damage to the respiratory passage
► Always use a filter or disposal bag!
When extracting dust that exceeds the
permitted limit values, only extract from
a single machine (electric or air tool).
Observe the following when extracting dust
generated by operating electric power tools:
Ensure there is adequate ventilation! Observe
regional regulations!
Limit values: exhaust air max. 50% of the clear
air volume
Formula: room volume V
8.3 Extracting wet materials/liquids
Remove the filter/disposal bag.
Use a special wet filter (NF-CT).
The dust extraction stops automatically when
the maximum fill level is reached.
18
x air renewal rate L
R
It must be ensured that the machine (main fil­
ter, suction hose, container, etc.) is sufficiently
dried after extracting wet materials.
Hazardous dust
Damage to the respiratory passage
► After extracting wet materials, remove the
wet filter and replace it with the main filter
for dry materials.
Escaping foam and liquids
► Switch off and empty the machine immedi­
ately.
8.4 After finishing work
► Variants with AutoClean only: Clean the
main filter automatically or manually (see
section 7.5)
► Switch off the mobile dust extractor and
pull out the mains plug.
► Wind up the mains power cable.
► Empty the dirt trap.
► Place the mobile dust extractor in a dry
room inaccessible to unauthorised users.
9

Service and maintenance

Risk of injury, electric shock
► Always pull the mains plug from the socket
before performing any servicing and main­
tenance work.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
Customer service and repairs must only be
carried out by the manufacturer or service
workshops: Find the nearest address at:
W
www.festool.com/service
EKAT
4
5
3
2
1
CAUTION
CAUTION
WARNING