Safety Warnings - Festool CTL 26 E Notice D'utilisation

English
Contents

1 Safety warnings.........................................14

2 Symbols..................................................... 15
3 Parts of the device.....................................15
4 Technical data........................................... 16
5 Intended use..............................................16
1 Safety warnings
WARNING! Read all safety warnings, instructions, illustrations and
specifications provided with this power tool. Failure to follow all instruc­
tions listed below may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
- This machine must not be used by persons (including children) with re­
duced physical, sensory or mental capabilities, or lack of experience
and knowledge. Children need to be supervised to ensure they do not
play with the machine.
- WARNING The machine may contain hazardous dust. Only have the ma­
chine maintained and emptied, and only have the filter replaced by an
authorised specialist using suitable protective equipment.
- Always operate with the filter system installed.
- Risk of explosion and fire! Do not extract:
- Sparks or hot dust;
- combustible or explosive materials (e.g. magnesium, aluminium, pet­
rol, diluting agents);
- aggressive materials (e.g. acid, alkaline solutions, solvents);
- chemically reactive materials, which lead to the generation of heat,
acids/bases, gases, etc. (e.g. reactive two-component materials, alu­
minium and water).
- Observe all national safety regulations as well as the material manufac­
turer's specifications.
- Always use suitable protective equipment.
- If intact following a visual inspection, work in a dry environment accord­
ing to instructions.
- Only use the electrical outlet module on the machine for its stated pur­
pose.
- Check the plug and the cable regularly in order to prevent a hazard. In
the event of damage, these must be replaced by an authorised service
workshop only.
- Do not lift or transport the machine using a crane hook or lifting gear.
14
6 Commissioning..........................................16
7 Settings......................................................17
8 Working..................................................... 18
9 Service and maintenance..........................18
10 Environment.............................................. 19
11 General information.................................. 19