Service And Maintenance; Changing The Filter Element - Festool CLEANTEX CTM 26 E Notice D'utilisation D'origine/Liste De Pièces De Rechange

Remember: A moist main filter clogs more quickly
when extracting dry materials. Therefore, dry the
main filter before extracting dust or replace the
damp filter with a dry one.
8.5 Extracting wet materials/liquids
Remove the filter or disposal bag!
Recommendation: use special wet filter
(NF-CT).
The dust extractor stops automatically when the
maximum level is reached.
After wet extraction, allow the main filter to dry!
CAUTION
Escaping foam and fluids

Switch off and empty the machine immediately.
8.6 The antistatic system
Friction inside the extraction hose causes static
electricity to develop during extraction. Operating
personnel may receive unpleasant electric shocks
while working. The mobile dust extractor is fitted
with an antistatic system as standard to discharge
any static electricity that may develop. However, al-
ways use the enclosed antistatic extraction hose.
8.7 After finishing work

Only versions with AutoClean: Clean the main
filter automatically or manually (see chapter
8.2).

Switch off the mobile dust extractor and pull out
the mains plug.

Wind up the mains power cable.

Empty the dirt trap.

Close off the extractor opening [1-2] using the
sealing plug [1-1].
WARNING
Hazardous dust
Damage to the respiratory passage

Wipe down the mobile dust extractor and clean
all accessories thoroughly using the extractor
(inside and out) before removing from the work-
ing area.

Parts that you were not able to clean thoroughly
must be sealed in an airtight plastic bag prior to
transportation.

Wear a dust mask!
The machine shall be stored indoors only.

Place the mobile dust extractor in a dry room in-
accessible to unauthorised users.
9

Service and maintenance

WARNING
Risk of injury, electric shock

Always disconnect the mains plug from the
socket before performing maintenance work on
the machine!

All maintenance and repair work which requires
the motor housing to be opened must only be
carried out by an authorised service workshop.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at:
www.festool.com/Service
EKAT
Use only original Festool spare parts!
4
Order No. at:
www.festool.com/Service
5
3
2
1
Damaged safety devices and compo-
nents must be repaired or replaced in
a recognised specialist workshop, unless otherwise
indicated in the operating manual.
Observe the following instructions:
– The manufacturer or an instructed person must
perform a dust test at least once a year to deter-
mine whether the filter is damaged, the machine
is sealed properly and the monitoring features
are functioning correctly.
– Anything that cannot be cleaned must be dis-
carded in impermeable bags. Observe applicable
disposal regulations!
– For user servicing, the machine must be disman-
tled, cleaned and serviced, as far as is reasonably
practicable, without causing risk to the mainte-
nance staff and others. Suitable precautions in-
clude, decontamination before dismantling,
provision from local filtered exhaust ventilation
where the machine is dismantled, cleaning of the
maintenance area and suitable personal protec-
tion.
9.1

Changing the filter element

NOTE
Motor damage

Never operate the extractor without a filter ele-
ment fitted as the motor may become damaged.
CTM
GB
17