Festool CLEANTEX CTM 26 E Notice D'utilisation D'origine/Liste De Pièces De Rechange page 15

7 Settings
7.1 Adjusting the hose diameter

Adjust the hose diameter adjuster [1-9] to
match the diameter of the connected hose.
 The monitoring devices will measure the air
speed in the extractor hose correctly as a result
(see chapter 7.9).
7.2 Connecting electric power tools
WARNING
Risk of injury

Observe the maximum appliance socket con-
nected load (see chapter "Technical data")

Switch off the electric power tool.

Connect the electric power tool to the appliance
socket [1-4].
7.3 Connecting pneumatic tools
WARNING
Risk of injury

Switch off the air tool.
Automatic on/off switch for air tools (CTM 36 E LE,
CTM 36 E LE AC, CTM 48 E LE, CTM 48 E LE AC or
accessories)
with compressed air module in module slot [1-3]
Recommendation:
– Attachment of service unit VE (495886): com-
pressed air filtered and lubricated
– Use of IAS system with IAS connector (454757)
for Festool air tools
Requirement: tool with operating pressure of
6 bar!
7.4 Adjusting the suction power

Use the rotary knob [1-10].
7.5 Applying the brake
Folding out the black brake lever [1-15] prevents
the mobile dust extractor from rolling. To achieve
this, lift the front end of the mobile dust extractor
slightly and push the black brake lever downwards
until it latches into place. Push the green lever [1-
14] again to release.
7.6 Temperature cut-out
A temperature cut-out switches the mobile dust ex-
tractor off when it reaches a critical temperature to
prevent overheating.

Switch off the mobile dust extractor, allow to
cool for about 5 minutes then switch on again.
 Not possible to switch on: contact Festool ser-
vice workshop.
7.7 Changing the filter bag (SC FIS-CT 26/
36/48)
Removing the filter bag [4]

Open the locking clips [2-2] and
remove the top section of the machine [2-1].

Remove the filter bag.

Dispose of the used filter bag in accordance with
statutory regulations.

Clean the dust container [2-3].
Inserting the filter bag [5]

Insert a new filter bag (SC FIS-CT 26/36/48) in
the inlet port of the dust container and interlock
it. Important: be aware that the locking engag-
es.

Replace the top section [2-1] and close the
locking clips [2-2].
 Make sure that the filter bag is not pinched be-
tween the top and bottom sections.
7.8 Changing the disposal bag
Removing the disposal bag [6]

Close off the extractor opening [1-2] using the
sealing plug [1-1].

Open the locking clips [2-2] and
remove the top section of the machine [2-1].

Close the disposal bag.

Remove the disposal bag.

Dispose of the used disposal bag in accordance
with statutory regulations.

Clean the dust container [2-3].
Inserting the disposal bag [7]

Insert a new disposal bag (ENS-CT26/36/48) on
the inlet nozzle of the container and lock in po-
sition.
Important: The lateral openings on the disposal
bag must be positioned inside the container.
Make sure that the bolt engages.

Place the disposal bag over the edge of the con-
tainer.
Make sure that the contacts [10-2] are free.

Replace the top section [2-1] and close the
locking clips [2-2].
CTM
GB
15