Initial Operation; Switch On/Off; Connecting Pneumatic Tools - Festool CLEANTEX CTM 26 E Notice D'utilisation D'origine/Liste De Pièces De Rechange

GB
CLEANTEX CTM/ CTM AC
6 Operation
WARNING
Unauthorised voltage or frequency!
Risk of accident
The mains voltage and the frequency of the
power source must correspond with the
specifications on the machine's name plate.
In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
may be used.
6.1

Initial operation

Open the locking clips
top section of the machine[2-1].
Remove the accessories from the dust con-
tainer [2-3] and the packaging!
Insert a filter or disposal bag in the dirt trap
(see chapter 7.7 and 7.8).
Replace the top section
locking clips [2-2].
Attach the cable holder to the rear of the
mobile dust extractor (see Fig. [3]).
Connect the suction hose to the machine.
6.2

Switch on/off

Insert the plug into an earthed socket.
WARNING
Risk of injury from tools starting up un-
expectedly
Before setting the switch to the "AUTO" or
"MAN" position, make sure that the con-
nected tool is switched off.
The switch [1-11] serves as an on/off switch.
Switch position "0"
Appliance socket [1-4]
power, mobile dust extractor is switched off.
"MAN" switch position
Appliance socket [1-4]
er, the mobile dust extractor starts.
"Auto" switch position
Appliance socket [1-4]
er, the mobile dust extractor starts when the
connected tool is switched on.
16
All manuals and user guides at all-guides.com
[2-2] and remove the
[2-1] and close the
is disconnected from the
is connected to the pow-
is connected to the pow-
7 Settings
7.1 Adjusting the hose diameter
Adjust the hose diameter adjuster
match the diameter of the connected hose.
The monitoring devices will measure the air
speed in the extractor hose correctly as a re-
sult (see chapter 7.9).
7.2 Connecting electric power tools
WARNING
Risk of injury
Observe the maximum connected loads
for the appliance socket (see chapter
"Technical data").
Make sure that the power tool is switched
off before connecting or disconnecting.
Connect the electric power tool to the appli-
ance socket [1-4].
7.3

Connecting pneumatic tools

WARNING
Risk of injury
Make sure that the pneumatic tool is
switched off before connecting or discon-
necting.
If the compressed air module
included in scope of delivery of CTM 36 E LE,
CTM 36 E LE AC) is installed, the automatic
switch-on function of the mobile dust extractor
also works in combination with air tools.
We also recommend installing the VE service
unit (495886). The service unit filters and lubri-
cates the compressed air and enables an ad-
justment of the air pressure. An IAS adapter
(454757) is available to connect Festool air
tools to the IAS system.
The operating pressure of the tool must be 6
bar for the automatic switch-on unit to function
correctly.
7.4 Adjusting the suction power
You can use the suction power adjuster
to adapt the machine suction power to different
applications.
[1-9] to
[1-3] (496141;
[1-10]